This "double lever" set trigger has a front trigger lever to engage the sear, so the lock can be fired with the trigger unset when properly tuned. The photo shows this trigger in the "set" position. The photo shows the maximum spacing of the two triggers. Although the rear trigger is gently curled, this trigger can be used with a medium size triggerguard bow. The trigger plate is about .400" wide. Neatly finished, this trigger has just enough backlash or "free-play" to allow the lock to be cocked, before the trigger is set. Shortening the mainspring's tip will increase free-play, if necessary. Your lock must have a "fly" detent in half cock. We can supply spare parts for this trigger. Available as a kit, or assembled, tuned, ready for use.
This trigger is a precision assembly made with heat treated tool steel. If either trigger must be bent to fit the triggerguard, heat the trigger to a cherry red and bend while hot. Reharden by heating to cherry red and quenching in 10W oil or mineral oil. Temper by heating to 550 degrees for 1 hour in a kitchen oven. The trigger bar can be bent slightly without heating.
Overall length 5-1/2", width .400".
Adobe Reader required to view the files below.
|
page_348.pdf
Last updated:4/25/2012
(93 KB)
| | |
|
|
Steel Dowel Pin, 3/32" diameter, 1-1/2", hardened, for lug, pipe, guard, or trigger pivot pin
|
|
|
|
Trigger mainspring, tempered steel, fits several double set triggers
|
|
|
|
Trigger mainspring screw, 3/8", 6-40 thread, fits several double set triggers
|
|
|
|
Trigger adjustment screw, 3-48 thread, fits several double set triggers
|
|
|
|
Trigger, front, tempered steel, for #TR-DST-6 double set triggers
|
|
|
|
Front trigger spring, tempered steel, fits several double set triggers
|
|
|
|
Trigger plate, for DST-6 trigger, as cast, plate only, .400" wide
|
|
|
|
trigger, rear, tempered steel, for #TR-DST-GA double set triggers
|
|